We will match any dealers advertised prices!

Mechanical Type Fasteners


DYNASTICK
SELF ADHESIVE INSULATION HANGER

SAH Dynastick is an insulation hanger with a self-stick base. Just peel the release paper from the hanger base and firmly press the base to the clean duct surface. Impale the insulation over the hanger nail and slip on the locking washer. Self-stick hangers adhere to clean metal surfaces and withstand temperatures of up to 175°F.

Available in 3/4", 1-1/4", 1-3/4", 2", & 2-1/2".



DYNASTICK
INSULATION HANGER

PBH Dynastick is a perforated base hanger for use with super strength PBA mastic. Simply place a small amount of PBA on a perforated base and firmly press hanger against the duct surface. Impale the insulation over the hanger nail and slip on a locking washer. Duro Dyne PBA adheres to concrete, metal or wood surfaces and withstands constant temperatures up to 180°F.

Available in 3/4", 1-1/4", 1-3/4", 2", & 2-1/2".



FLIPSTIX
SELF ADHESIVE INSULATION HANGER WITH THE UNIQUE “ONE PIECE” DESIGN!

A unique insulation hanger with a self stick base. One fastener can be used for insulation up to 2” thick. Optional extension extends use for up to 6” thick insulation or wrap. It is the only fastener available in galvanized, aluminum and stainless steel. Insulation can be secured simply by bending the tip of the extended pin or using supplied washers. Flipstix can be used on any clean metal or painted surface and will withstand temperatures of up to 175°F.



STIK-TAC
SELF ADHESIVE INSULATION HANGER

Stik-Tac Insulation fasteners are an economical solution to self-stick insulation needs. Stik-Tacs have a 1-3/8 inch square base and high strength acrylic foam tape for superior holding power. Just peel off the protective backing and firmly press the base on to the cleaned duct surface. To complete the installation impale the insulation on the nail and secure with an LPC steel or NC1 nylon washer. Withstand temperatures up to 175°F.

Available in 1-3/4" & 2-1/2".



BANGER
IMPACT DRIVEN FASTENERS

Easy to install -place the liner over the sheet metal and drive the banger through the insulation. Upon impact, the jaws (three on the Tripod® for added stability, two on the standard Banger), of the fastener penetrate the metal and lock securely within the thickness of the metal itself. (Always place a hardened steel block behind the sheet metal at the point of impact). Bangers can be installed with model DHH Double Headed Hammer or AB-5 Automatic Banger Setter.

BG available in 1/2" & 1".
TBG available in 1/2", 1", 1-1/8" & 1-1/2".